Insert blade (J) through slot in the side of the motor assembly (C), ensuring the “THIS SIDE UP” label faces the ceiling. Then re-insert the mounting bracket screws (M) and securely tighten all screws.Ģ. Slide the canopy (B) over the mounting bracket (A), aligning the slotted holes in the canopy (B) with the pre-loosened mounting bracket screws (M) in the mounting bracket (A). Loosen all four mounting bracket screws (M), then completely remove two mounting bracket screws (M) from opposite sides of the mounting bracket (A). Place the Green and White wire connections on the opposite side of the outlet box from the Black. WARNING: Ensure no wire strands are visible after making connections. Turn the spliced/taped wires upward and gently push the wires and wire connectors (AA) into the outlet box. Wrap electrical tape (not included) around each individual wire connector (AA) down to the wire.ģ. If supply wires are different colors than referred to above, a professional electrician should determine the proper wiring.Ģ. The White wire is neutral for the fan and light kit. Note: The Black wire is hot power for the fan. Secure all wiring connections together with wire connectors (AA). Connect the Black wire from the fan to the Black (hot) supply wire.Connect the White wire from the fan to the White (neutral) supply wire.Connect the Green wire from the mounting bracket (A) to the Bare/Green (ground) supply wire.Connect supply and fan wires according to the diagram and these steps: If your house wire is larger than 12-gauge and/or there is more than one house wire to connect to the two fan lead wires, consult an electrician for the proper size wire connectors to use.ĬAUTION: Be sure the outlet box is properly grounded or that a ground (green or bare) wire is present.ġ. WARNING: To reduce the risk of fire, electrical shock or personal injury, wire connectors provided with this fan are designed to accept only one 12-gauge house wire and two lead wires from the fan. Raise the fan and place the canopy (B) on the hook on the mounting bracket (A), temporarily leaving hands free for the wiring process.CAUTION: It is very important you use the proper hardware when installing the mounting bracket (A) as it will support the fan. Then, secure the mounting bracket (A) to the outlet box (not included) using screws and washers provided with the outlet box. Feed the supply wires from the outlet box through the center hole in the mounting bracket (A).Then, turn the orange shipping block counterclockwise and remove. Loosen the four light pan screws (K) preassembled to the fitter plate (D). ![]() from any obstructions and will be at least 7 ft.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |